Written by Chiara
Edited on
15 October 2024
·
08:40
The most common errors of AEG washer dryer combinations
Does your AEG washer dryer combination display an error code? In that case, the appliance has an error. That's inconvenient, but you can often solve it by yourself. The drain hose might be too deep in the drain, or there's a bend in the supply hose, for example. You can read which errors are most common and how to solve them here.
AEG error code E20, F2, or C2
If your washer dryer combination has an E20, F2, or C2 error, there's something going on with the water drain. First, check the drain hose. Make sure it's not deeper in the drain pipe than 10cm, and that there's no bend in it. It's also important that the drain pipe isn't higher than 1m. Finally, make sure the filter isn't blocked and clean it. Read how to do this in the article below.
AEG error code E10, F1, or C1
With the error code E10, F1, or C1, there's a problem with the water supply. First, check if the water supply is fully open. Is the error still there? Close the supply, detach the supply hose, and clean the filter at the end. You can use a toothbrush for this, for example. Afterwards, attach the hose again and make sure there's no bend in it. Lastly, turn on the appliance and start your wash cycle.
AEG error code EH0 or EHO
Do you see an error code EH0 or EHO? In that case, there's an issue with the power supply. First, check if the socket itself is the cause by connecting a different device. Isn't that working either? Call an electrician. Do other appliances work? Unplug the connector from the washer dryer combination and wait 30 seconds. Plug it into the socket again, and turn on the washer dryer combination.
AEG error code EF0 or EFO
The error codes EF0 or EFO have several causes. The drain filter could be blocked. Place a bucket in front of the hatch at the bottom of the appliance and remove the filter. Next, clean the filter and the filter hole thoroughly and place it back. There could also be too much detergent with your laundry. In that case, wait a few hours until the foam has disappeared and then run an empty drum at 60°C.
Problem not solved?
Does your washer dryer combination display a different error? Check the manual of the appliance what the cause and solution are. It can also help to unplug the machine for 30 minutes and then restart the cycle. Doesn't the error code go away? Not all errors can be fixed by yourself. In this case, contact the seller of your AEG washer dryer combination. Don't have a warranty on your washer dryer combination? Contact AEG.
Article by Chiara
Washer Dryer Combination Expert.
