The table clamp construction is very well thought out. You don't have the typical turning knob sticking out at the bottom!
I'm glad I chose this somewhat more expensive, solid one with gas spring. I think the finish is excellent.
The construction drawing is well thought out with letters and letters on the separate bags with bolts and parts. So you can carry out step by step and only open the correct bags when you are at that step. Never seen before, very good.
Pivot points were stiff, not or hardly greased. So spray some grease on them yourself. No penetrating oil from the well-known 40 brand and PFAS free. Suddenly the arm turns and hinges very smoothly and neatly.
So glad I finally have this and that monitor foot, which also had too little rotation (limited in the foot for no apparent reason) is now off the table! The monitor can now be turned a quarter turn or more super easily.
However, I had made a mistake in the 'length', how far the arm can go from the pivot point. The drawing, which is neatly included with the product description, fortunately, was not read or understood correctly. So 5-6cm shorter than desired. I would like that length a bit longer, extra segment, up to 80-90 cm reach, but that does not seem feasible with a table clamp foot: many alternatives looked at and all in the same order of magnitude 'length'. Then this is in my opinion the most beautiful design.
